Snap Circuits Electronics
Snap Circuits Electronics
Check out this page if you are looking for Snap Circuits Electronics
![]() |
![]() Snap Circuits Jr SC 100 Electronics NEW US $26.23
|
![]() Elenco Snap Circuits Extreme SC 750 Electronics Science Kit NEW US $92.99
|
![]() Snap Circuits Jr By Elenco SC 100 Learn About Electronics New US $21.99
|
![]() AWARD WINNING ELENCO SNAP CIRCUITS PRO 500 ELECTRONICS KIT US $65.95
|
![]() Electronic Snap Circuit Jr Model SC 100 with Manual EDU US $39.99
|
![]() Electronic Snap Circuits 300 with FREE Storage Bag US $69.09
|
![]() SC 500 SNAP CIRCUITS PRO ELECTRONICS KIT NEW US $89.00
|
![]() Elenco Electronics Snap Circuits Pro 500 1 ELESC 500 US $89.25
|
![]() Electronic Experiment Kit with Computer Inteface Snap Circuits US $72.01
|
![]() Electronic Experiment Kit with Computer Inteface Snap Circuits Pro US $88.99
|
![]() Electronic Snap Circuits US $64.99
|
![]() Electronic Experiment Kit with Computer Inteface Snap Circuits NEW US $81.99
|
![]() Elenco Electronic Snap Circuits SC 300 US $83.08
|
![]() Electronic Snap Circuits SC 300 Bu Elenco Have Fun Learning About Electronics US $20.00
|

Starting a 2 stroke motor without pullstart?
Hi All - hoping someone can advise me on a problem i have with a motor...
Background - i know VERY LITTLE about mechanical engineering (electronics and circuit boards are my thing).
My son has a motorised skateboard. It has a 34cc 2 stroke engine that drives a rear wheel. The pull start broke on it after very little use, has been replaced and then the 'claw' snapped on it. That has been replaced and has gone again within a few 'pulls'. Major problem is that this is a cheap/nasty china cheap import and the motor/parts that just aren't made to last.
I'm looking for a solution to get this motor running. It has no gears/clutch (just a throttle/brake). I'd appreciate any advice.
My questions are:- Is it possible to 'bump start' a motor that doesn;t have clutch? Also, a freind, who knows as little about motors as me, says that you can start the motor with a common workmans drill - is this so? If not, is it possible to buy electric starts for this type of 'mower' engine...?
If you remove the covers from the pull start, remove all the ratchets and bits. You will be left with the output shaft from the engine. Try to see if you can fit a bolt on to the end of the shaft. The best way to start the engine will be with a pneumatic ratchet as this will overcome the problem of the engine biting after it start.
Another thing to think about is to bin the motor that is on the skateboard and replace it will a motor from a mini motor.


US $28.19














































































